TDK Lambda | Z+Low Voltage User Manual

7.12.7 INITiate Subsystem INITiate Enables the trigger subsystem. If a trigger circuit is not enabled, all trigger commands are ignored.

SCPI Command Syntax GEN Command Syntax

INITiate[:IMMediate]

None None

Parameters Examples Query Syntax

INIT:IMM

None

INITiate:CONTinuous • INIT:CONT 0 - Enables the trigger subsystem only for a single trigger action. The subsystem must be enabled prior to each subsequent trigger action. • INIT:CONT 1 - Trigger system is continuously enabled and INIT is redundant.

SCPI Command Syntax

INITiate:CONTinuous

Parameters Examples Query Syntax

0|OFF 1|ON

INIT:CONT 1 INIT:CONT ON

INITiate:CONTinuous?

Returned Parameters

0 |1

NOTE: When power supply is in INIT:CONTONmode, it’s impossible to change any programming parameter. Display shows ” Err ” . Send ABORt commands to allow parameter change.

7.12.8 LIST Subsystem This subsystem receives parameters to create a step waveform of the output voltage or current.

NOTE: All list subsystem commands (as well as CURR:MODE LIST and VOLT:MODE LIST) are implied ABORt commands.

LIST:COUNt Sets the number of times that the list is executed before it is completed. The command accepts parameters in the range 1 through 9999, but any number greater than 9999 is interpreted as INFinity. Use INF if you wish to execute a list indefinitely.

SCPI Command Syntax

[SOURce]:LIST:COUNt

Parameters

1 to 9999 | INFinity

*RST

1

Examples

LIST:COUN 3 LIST:COUN INF

Query Syntax

[SOURce]:LIST:COUNt? (if count>9999 the response is INF)

Returned Parameters

107