TDK Lambda | Z+High Voltage User Manual

CAUTION: When using shielded sense wires, ground the shield in one place only. The location can be the power supply chassis or one of the output terminals.

Use remote sense where the load regulation at the load end is critical. In remote sense, the power supply will compensate for voltage drop on the load wires. Refer to the specifications for the maximumvoltagedropon loadwires.Thevoltagedrop is subtracted fromthe total voltageavailable at the output. Follow the instructions below to configure the power supply for remote sensing: 1. Ensure that the AC On/Off is in the Off position. 2. Remove the local sense jumpers from J2. 3. Connect the negative sense lead to terminal J2-1 (-S) and the positive sense lead to terminal J2-5(+S) of the J2 mating connector. Ensure that the J2 mating connector is plugged securely into the rear panel sense connector, J2. 4. Turn On the power supply. 1. If the power supply is operating in remote sense and either the positive or negative load wire is not connected, an internal protection circuit will activate and shut down the power supply. To resume operation, turn the AC On/Off to the Off position, connect the open load wire, and turn On the power supply. 2. If the power supply is operated without the remote sense lines or local sense jumpers, it will continue to work, but the output voltage regulation will be degraded. Also, the OVP circuit may activate and shut down the power supply. NOTES:

3.10.4 J2 Sense Connector Technical Information - J2 connector type: 43650-0501, MOLEX. - Plug type:43645-0500, MOLEX. - Contact pins: 43030-0002, MOLEX. - Hand tool: 63819-0000, MOLEX - Wire AWG: 24 up to 20

3.11 Repackaging for Shipment To ensure safe transportation of the instrument, contact the TDK-Lambda sales or service facility near you for Return Authorization and shipping information. Please attach a tag to the power supply describing the problem and specifying the owner, model number and serial number of the power supply. Refer to Warranty Information for further instructions.

47