TDK Lambda | Z+High Voltage User Manual

SAFETY VENTILATION The ventilation openings on these products must not be covered. Ensure that there is at least 10cm spacing between any obstruction and the ventilation openings. INPUT AND OUTPUT CABLES Must use cableswith the appropriate voltage and temperature ratings toensure safe, reliableoperation. ACCESSORIES Only accessories which meet the manufacturer’s specifications shall be used. For identification and instructions for connection of accessories, refer to the user manual. HANDLING, LIFTING AND CARRYING Handling, lifting and carrying of the equipment shall be made only according to the instructions specified in the user manual to avoid potential personal injury. DISCONNECT DEVICE The appliance coupler is the main disconnect device of the equipment which reliably shuts off the supply from the equipment. The positioning of the equipment must not make it difficult to operate the disconnect device. NOTE: The switch incorporated in the equipment does NOT act as a main disconnect device and does not cut the supply or power from the equipment. It is added as a means to shut down certain circuits inside the power supply such as the display and the output circuit. INSTALLATION Installation of the equipment or the system incorporating the equipment must be in accordancewith the installation instructions provided by the manufacturer. The safety of any system incorporating the equipment is the responsibility of the assembler. IMPROPER USAGE OF THE EQUIPMENT If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired. RACK MOUNTING SAFETY INSTRUCTIONS A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma)specified by the manufacturer. B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised. C) Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading. D) Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuitsmight have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern. E) Reliable Earthing - Reliable earthing of rack-mounted equipment should bemaintained. Particular attention should be given to supply connections other than direct connections to the branch circuit (e.g. use of power strips). USERS This equipment must be operated only by qualified personnel who understand the instructions and safety manuals provided with the equipment. If the equipment must be operated by an unqualified personnel, then he/she must be supervised by a qualified personnel.