TDK Lambda | Z+High Voltage User Manual

5.3.5 Protection Delay........................................................................................................................................... 62 5.3.5.1 Setting the Protection Delay............................................................................................................. 62 5.3.6 Over Temperature Protection............................................................................................................... 62 5.3.7 AC Fail Alarm................................................................................................................................................... 62 5.4 Series Operation............................................................................................................................. 63 5.4.1 Series Connection for Increased Output Voltage..................................................................... 63 5.4.2 Series Connection for Positive and Negative Output Voltage......................................... 64 5.4.3 Remote Programming in Series Operation.................................................................................. 64 5.5 Parallel Operation.......................................................................................................................... 65 5.5.1 Introduction..................................................................................................................................................... 65 5.5.2 Basic Parallel Operation............................................................................................................................ 65 5.5.2.1 Master Unit Set Up................................................................................................................................... 65 5.5.2.2 Slave Unit Set Up...................................................................................................................................... 66 5.5.2.3 Setting Over Voltage Protection..................................................................................................... 66 5.5.2.4 Setting Foldback Protection.............................................................................................................. 66 5.5.2.5 Connection to Load................................................................................................................................ 66 5.5.3 Advanced Parallel Operation................................................................................................................ 68 5.5.3.1 Master Unit Set Up................................................................................................................................... 68 5.5.3.2 Slave Unit Set Up...................................................................................................................................... 68 5.6 Daisy-Chain Connection.............................................................................................................. 69 5.7 Rear Panel (J3 Connector) Functions and Settings............................................................ 69 5.7.1 External Shut Off Function...................................................................................................................... 70 5.7.2 Interlock Function - Analog On/Off. (Enable/Disable)........................................................... 70 5.7.3 Auxiliary Programmed Function Pin 1 and Pin 2...................................................................... 71 5.7.4 Power Supply OK Signal........................................................................................................................... 72 5.8 Rear Panel (J1 Connector) Functions. ..................................................................................... 72 5.8.1 CV/CC Signal.................................................................................................................................................... 72 5.9 Parameter Setting Memory........................................................................................................ 73 5.9.1 Default Setting............................................................................................................................................... 73 5.9.2 Reset..................................................................................................................................................................... 73 5.9.3 Last Setting Memory.................................................................................................................................. 73 5.9.4 Save <1..4>........................................................................................................................................................ 74 5.9.5 Recall <1..4>..................................................................................................................................................... 74 CHAPTER 6: REMOTE ANALOG PROGRAMMING 6.1 Introduction..................................................................................................................................... 76 6.2 Local/Remote Analog Control................................................................................................... 76 6.3 Local/Remote Analog Indication. ............................................................................................ 76 6.4 Remote Voltage Programming of Output Voltage and Current................................... 77 6.5 Remote Resistor Programming of Output Voltage and Output Current................... 78 6.6 Programming Monitoring of Output Voltage (V_MON) and Current (I_MON)...... 79 CHAPTER 7: Serial RS232/RS485 and USB Interface 7.1 Introduction...................................................................................................................................... 80 7.2 Configuration................................................................................................................................... 80 7.2.1 Default Setting............................................................................................................................................... 80 7.2.2 Address Setting.............................................................................................................................................. 80 7.2.3 Communication Interface Selection ................................................................................................ 80 7.2.4 Baud Rate Setting......................................................................................................................................... 81 7.2.5 Language Selection (RS232/RS485, USB)....................................................................................... 81 7.2.6 Setting Unit in Remote, Local Lockout or Local Mode.......................................................... 81 7.3 Rear Panel RS232/485 Connector............................................................................................. 82 7.4 Connectig Power Supply To RS232 Or RS485 BUS.............................................................. 83 7.5 Rear Panel USB Connector.......................................................................................................... 84