TDK Lambda | Z+High Voltage User Manual

8.5 Trigger

Subsystem Level

Display Function Level

Display Parameter Level Display

Description

Initialization (Refer to command INIT) ready for trigger.

INIT



INIT

n

TRIG ENA

G

n

refer to command INIT:CONT

Continue

n

DIS



BUS (via Software or front Panel),

Trigger IN (input trigger)



refer to command TRIG:SOUR

 

Trigger Setting

G

EXT (Analog)



refer to command TRIG:DELAY. Fine and Course modes

Trigger delay

0-65sec





OFF



refer to command OUTP:TTLT:MODE

Trigger

Trigger OUT

G



Function Strobe

.

Refer to commands LIST:LOAD and WAVE:LOAD

LOAD List or Wave data

L1…L4





(Refer to LIST:COUN andWAVE:COUN) allow course and fine setting (Refer to LIST:STEP and WAVE:STEP)

COUNter (set repeat time)

1…9999

N



Programming

G

ONCE AUTO



STEP setting





ABORt execution

(Refer to command ABORt)

YES





Table 8-1: Trigger and Programming front panel menu

NOTE: At AC power ON the display shows last selected program list but dosen’t load it from memory. NOTE: If during program selection L1-L4, display shows ” ERR ” message then programmemory is empty or power supply is in initiated state. Select ”ABORt” to EXIT from initiate state. 8.5.1 Input Trigger Trigger source can be set via: • BUS - Command (Refer to section 7.11 *TRG, 7.12 TRIGger) or Front Panel. • EXT - Rear panel connector J3-8 (Refer to section 4.3.2). Input Trigger source setting via Front Panel: 1. Press MENU button. MENU (green) LED illuminates. ” set ” message appears on the Voltage display. 2. Rotate Voltage encoder until ” triG ” message appears on Voltage display. 3. Press Voltage encoder. ”  ” message appears on Voltage display. 4. Rotate Voltage encoder until ”  I ” message appears. Press Voltage encoder. 5. ”  I ” message appears on Voltage Display and ”  ” or ”  ” messages appear on Current display. Rotate to scroll list and press Current encoder to select.

122